Both feet cleaned up, drilled out and ready for pinning:
I tried to drill them out with a power Dremel, but didn't like the lack of control. So switched the 3mm drill bit to my GW hand drill and that produced much tidier results. In each case I predrilled with a much smaller bit to ensure it was central. The space is exactly 3mm, so there is no room to be off centre:
Next up, the pinned feet. At this stage the joints are still fully articulable (a little more cleaning up required on the big toe):
The pin from the big and rear toes extends into the ankle socket:
This will assist in pinning the lower leg in place:
Next week - the legs!